![]() ![]() When I select 128-bit WEP encryption on the WLC, I receive an error that says that 128-bit is not supported on the 1240s: spam_lrad.c 12839: Not creating SSID mde on CISCO AP xx:xx:xx:xx:xx:xx because WEP128 bit is not supported. I have a Wireless LAN Controller (WLC) 4402 and I use 1240 lightweight access points (LAPs). In other words, if AP-manager 1 uses port 1 as the primary and port 2 as the backup, AP-manager 2 must use port 3 as the primary and port 4 as the backup. But make sure that your primary port and backup port configurations for each manager do not overlap. You mustcreate a second AP-manager interface in order to bring up additional APs. The maximum number of APs on interface 1 is reached.Ĭonfigure multiple AP-manager interfaces and configure primary/backup ports that other AP-manager interfaces do not use. Otherwise, you receive the error that looks like this: Wed Sep 28 12:26:41 2005 spam_lrad.c 4212: AP cannot join because Why does the error occur?Ī.You must create additional AP-manager interfaces in order to support more than 48 APs. The conversion of 48 APs was completed, and the message received on the WLC stated: spam_lrad.c 4212: AP cannot join because the maximum number of APs on interface 1 is reached. The conversion of more than 200 access points (APs) from Cisco IOS® Software to Lightweight AP Protocol (LWAPP) with a Cisco 4404 WLC was begun. Refer to Cisco Technical Tips Conventions for more information on document conventions. This document describes frequently asked questions (FAQ) on error messages and system messages for the Cisco Wireless LAN (WLAN) Controllers (WLCs).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |